Meliconi Gumbody Facile Light - Manual (Page 5)

C U R R E N T C O D E D I S P L AY
To find out the code of your remote control, follow this procedure:
1. Hold down the MUTE and ON/OFF keys together for 5
seconds until the light indicator at the top starts to
flash.
2. Release the MUTE and ON/OFF keys and press and
release the 1-/-- key within 8 seconds.
3. After a few seconds, the light indicator produces 4
series of flashes, with a pause between each series,
corresponding to the current code. Count the number
of flashes; each series of flashes corresponds to one
figure in the code. 10 flashes correspond to 0.
4. Make a note of the code on the adhesive label inside
the battery cover for quick and easy future
reprogramming.
+
5 SEC.
........................................................ = 1
............................................ = 3
= 0
.......................... = 6
Code obtained = 1 3 0 6
N.B. this operation cannot be interrupted and the remote control cannot
therefore be used until the end of the 4 series of flashes.
LIGHT FUNCTION: Lights up the keys on the remote control
Press the LIGHT button to light up the remote control keys. This is very useful in the dark to find
which key to press.
The light goes out when the
LIGHT button is pressed again or after about 10 seconds if no keys are
pressed.
HOW TO USE THE ADDITIONAL COMMANDS WHICH DO NOT APPEAR ON THE KEYPAD
Find them on your F A C I L E L i g h t remote control by pressing the buttons one by one and discovering
the commands that interest you.
In particular, the additional functions most frequently used, such as
NORMALIZATION, COLOUR and BRIGHTNESS,
can be found on the following keys:
Normalization:
Brightness (+): or
Brightness (-): or
Colour (+): or
Colour (-): or
Although not indicated on the keypad,
some keys can be used for additional commands.
For less frequently used functions look for the additional commands on our website www.gumbodylight.com.
As well as easily finding the code to programme your remote control, the on-line guide will help you to
find which keys on the F A C I L E L i g h t remote control correspond to the additional commands.
11