Meliconi Speedy 2 combo User Manual
Page 3
19
Remember to always make a note of the 4-digit codes for your appliances on the inside of the battery cover
when the code search and saving are finished. The codes will be required if the remote control needs to be
re-programmed following accidental deletion.
To find the code for your remote control:
1. Simultaneously press and hold for 5 seconds the buttons corresponding to the appliance for which you
would like to enter the code:
and
for the analogue TV,
and
for the decoder, or
and
for the digital TV, until the indicator light starts to flash indicating that the remote control is in the
programming state.
2. Upon release insert the code number you noted beforehand. Three flashes indicate that the code has been
memorized correctly. If not, try the code entry procedure again starting from point 1.
PROGRAMMED CODE NOTING
RE-PROGRAMMING YOUR REMOTE CONTROL BY ENTERING THE CODE NOTED DOWN
1. Simultaneously hold down the
and
buttons for 5 seconds (if you want to know the codes for the
analogue or digital TV), or
and
(if you want to know the code for the decoder), until the indicator
light starts to flash indicating that the remote control is in the programming state.
2. Release the buttons and press and release the
button within 8 seconds.
3. After a short pause, the indicator light produces four series of flashes with a space between them,
corresponding to the code you are looking for. Count the number of flashes; each series of flashes
corresponds to one figure in the code. 10 flashes correspond to 0. For example, the code 1306 corresponds
to:
=
1
=
3
=
0
=
6
4. Make a note of the code on the adhesive label inside the battery cover for quick and easy consultation.
Identify and take note of the code which you have discovered
following the code noting procedure
(see “PROGRAMMED CODE NOTING” section).
NOTE: The indicator light flashes more quickly during the search operation.
The indicator light stops flashing and the remote control exits the programming mode in the following
cases:
• if no buttons are pressed for 12 seconds
• if the end of the code search list has been reached. In this case, consult the website
www.meliconi.com.