Exmark Lazer Z XS - Manual (Page 24)

19
IMPORTANT: Operator must be in seat before the PTO can be engaged.
Set throttle to "midway" position. Pull outward on the switch to the “ROTATE”
position. Accelerate to full throttle to begin mowing.
3.3.5 Stopping PTO: Set throttle to the “midway” position. Push in on the switch to the
“STOP” position stopping the PTO.
3.3.6 Stopping Engine: Bring unit to a full stop. Disengage the PTO, move motion
control levers out to the neutral lock position and set parking brake.
Before stopping the engine, place the throttle control midway between the “slow”
and “fast” positions. Allow the engine to run a minimum of 15 seconds; then stop
the engine.
Rotate ignition switch to “OFF” position. Remove the key to prevent children or
other unauthorized persons from starting engine.
Close fuel shut-off valve when machine will not be used for a few days, when
transporting, and when the unit is parked inside a building.
3.4 TRANSPORTING
3.4.1 Transporting a Unit: Use a heavy-duty trailer or truck to transport the machine. Lock
brake and block wheels. Securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes. Be sure that the trailer or truck has all necessary
lighting and marking as required by law. Secure a trailer with a safety chain.
CAUTION
POTENTIAL HAZARD
♦ This unit does not have proper turn
signals, lights, reflective markings, or a
slow moving vehicle emblem. These
items are required to drive on a public
street or roadway.
WHAT CAN HAPPEN
♦ Driving on a street or roadway without
such equipment is dangerous and can
lead to accidents causing personal injury.
♦ Driving on a street or roadway without
such equipment may also be a violation of
State laws and the operator may be
subject to traffic tickets and/or fines.
HOW TO AVOID THE HAZARD
♦ Do not drive a unit on a public street or
roadway.