Precision Digital PD6800 - Manual (Page 9)

PD6800-0L1 Loop-Powered Process Meter Instruction Manual
9
Electromagnetic Compatibility
EMISSIONS
EN 61326:2006
Safety requirements for measurement, control, and la-
boratory use – Industrial
Group 1 Class A ISM emissions requirements
Radiated
Emissions Class A
IMMUNITY
EN 61326:2006
Safety requirements for measurement, control, and la-
boratory use
ESD ±4 kV contact,
±8 kV air
RFI – Amplitude
Modulated 80-1000 MHz @ 10 V/m,
1.4-2.0 GHz @ 3 V/m,
2.0-2.7 GHz @ 1 V/m,
80% AM (1 kHz)
EFT ±2 kV DC mains, ±1 kV other
Telco Surge ±1 kV
CRFI 3 V, 0.15-80 MHz, 1 kHz 80% AM
SAFETY INFORMATION
WARNINGS
 Read complete instructions prior to installation and operation of the meter.
 Installation and service should be performed only by trained service
personnel. Service requiring replacement of internal components must be
performed at the factory.
 Disconnect from supply before opening enclosure. Keep cover tight while
circuits are alive. Conduit seals must be installed within 18" (450mm) of
the enclosure.
 Verify that the operating atmosphere of the meter is consistent with the
appropriate hazardous locations certifications.
 If the meter is installed in a high voltage environment and a fault or
installation error occurs, high voltage may be present on any lead
.