Precision Flight Serial Avionics and FS2004 User Manual
Page 2
Set Up Guide for Serial Avionics and FS2004
Page 2
Preface
This setup guide will walk you through the necessary steps to setup your Serial Digital
Avionics with Microsoft Flight Simulator 2004. For connection diagram please refer to diagrams
towards the end of this manual.
This setup guide assumes that you have already installed Microsoft Flight Simulator 2004
(FS2004) and have at least run it once. If you have not installed and run FS2004 software,
please install it now then run it at least once. Then refer to this guide once done. For reference
on software installation, please refer to the software manual that you have received.
INSTALLATION OF PFC DRIVER (DLL)
The PFC Serial Device Driver for FS2004, which includes the PFC.dll and FSUIPC.dll, is the
software that allows serial Precision Flight Controls, Inc. devices to communicate and work with
Microsoft Flight Simulator 2004 and Microsoft Flight Simulator X. Because of the internal
difference between the FS2004 and FSX please make sure that you have downloaded the
appropriate PFC Driver for the software that you are using.
1. Download the PFC Serial FS2004 Driver from our site:
2. When you click on the link it will ask where you want to save the file, make sure that you
save it on your Desktop.
3. Now that you have downloaded the driver please close your browser.
4. On your desktop, please look for the PFC_Serial_FS2004_Driver.exe, and double click on
it.
5. Click on Next.