Precision Flight Serial CAT I and Microsoft Flight Simulator 9 (2004) - Manual (Page 2)

Set Up Guide for Serial CAT1 and FS2004 Page 2
Preface
This setup guide will walk you through the necessary steps to setup your CAT I System with
Microsoft Flight Simulator 2004 (FS2004). For connection diagram please refer to the packet that you
received with the console.
It assumes that you have already installed FS2004 at least has ran it once. If you have not
installed and run it, please do so now and refer to this guide once that task is completed. For reference
on software installation, please refer to manual you received with your software.
It also assumes that you have the complete CAT I system, please see component list below for
a complete CAT I system. If you do not have the complete system, you will simply skip the part that
does not apply to you.
CAT I System includes:

Cirrus Yoke or Jetliner Column Yoke

Throttle Quadrant Console

Avionics Panel with Remote Instrument Controller

Cirrus Rudder Pedals
Set Up Phases:
A. Install the PFC Serial Driver for FS2004
B. Configure PFC Serial Driver for hardware communication
C. Enable and calibrate main controls
D. Enable and calibrate trim controls.
E. Enable Quadrants
F. Configure Consoles tab