Primare NP30 network player - Manual (Page 8)

N P 3 0 u s e r g u i d e

i N P u t s a N d o u t P u t s
Outputs
1 XLR
1 RCA
1 RCA SP/DIF (192 kHz)
Inputs
3 TOS-Link
1 RCA SP/DIF
1 USB-A
1 USB-B
1 Wi-Fi
1 LAN
Network
Wi-Fi b, g, n mode: WEP (64 and 128Bit), WPA
&WPA2 (TKIP & AES)
Audio formats
WAV, AIFF, FLAC, MP3, AAC, WMA, OGG, ALAC
Control
IR in and out,
Trigger in and out
RS232 for connecting to control systems
P e r f o r m a N c e
Frequency response
32 – 192kHz
Signal to Noise
120dB
Output impedance
RCA 100 Ω; XLR 110Ω
XLR/RCA output: Both 2.2V
g e N e r a l
Weight
8.5 kg
Dimensions
430 x 370 x 95 mm
Power consumption
Max: 20W
Standby: 0.5W
techNical sPecificatioN
P h a s e
The phase of the AC supply can make a significant
difference to the sound.
Ensure that the live pin of the AC power cable
is connected to the left-hand pin of the power
connector, viewed from the back panel:
Live
b u r N - i N
Your Primare will start to sound best after an
initial burn-in of approximately 24 hours.
You will notice a further smaller improvement in
sound quality for at least another 3 days’ playing.
u s b s a m P l e r a t e
To take advantage of the highest 24 bit/192kHz
setting offered by the NP30 you may need to
select an appropriate output setting on your
computer.
additioNal iNformatioN
The NP30 is a genuine 24/192 DAC incorporating an asynchronous master clock
for low jitter, and balanced XLR outputs for connection to a high quality music
system.
These instructions help you get the best possible sound from your NP30.