Retrotec House and Duct Simulator - Manual (Page 2)

Page 2 of 4
Remove the base frame from case and lay on the ground
in a rectangle as shown.
Secure the frame together using the bolts and
washers provided. Ensure brass knobs are on the
outside of the frame.
To install the legs, pair the colored dots on frame and
legs to ensure proper installation. Start by attaching
the tops of the legs to the tent frame.
You can now install the tent shell.
Note: the nylon washers
are not required here as
it is a non-moving part.
Now move to the bottom and attach as shown.
Attach the center braces to the outside edge of the leg
as shown.
● Ensure nylon washer is between frame pieces that can
move to prevent chaffing.
● Make sure knobs are tight, not just snug.
Assemble frame: Step 2
Assemble frame: Step 3 Assemble Frame: Step 1
2. Attach here
2. Attach here
1. Attach here
3. Attach here
3. Attach here
1. Attach here