Extech Instruments S4500THS - Manual (Page 12)

Portable Printing Solutions S4500THS User Guide
Extech Instruments Corporation 285 Bear Hill Road, Waltham, MA 02451-1064 Phone: 1-877-4-EXTECH (439-8324) Fax: (781) 890-7864 Web site: www.extech.com
Copyright © 2005 Extech Instruments Corporation. All rights reserved including the right of reproduction in whole or in part in any form.
8
3.2 C
ONNECTING THE
P
RINTER

The S4500THS printer supports Serial RS232 and IrDA compatible infrared
communication interfaces. Radio frequency (RF) Bluetooth communication is
available as an optional feature as well as 802.11b interface.

Serial, IrDA, Bluetooth and 802.11b communication settings can be changed
via a DIP switch located on the control card.

The DIP switch is located inside the battery compartment as illustrated
above indicating the location of this switch. Figure 6 shows the
DIP switch location.

The functions assigned to these switches are shown in Table 2.

If the Serial interface is selected, the communication Parameters, Baud rate,
Data Bit and Parity must be set.

Note: Optional serial cable is available for Serial RS232 communication
(part # 5892RJD9).

Printer drivers for Windows 95/98/NT/2000 and XP are available from Extech.

Printer CE print Control utility is available from Extech for
Windows CE devices.

Printboy Print Utility from Bachmann Software or PalmPrint Utility, from
StevensCreek, are recommended for Palm Pilot devices
F
IGURE
5 – S
AMPLE
S
ELF
T
EST
F
IGURE
6: D
IP
S
WITCH
L
OCATION