RIGOL DG1000Z Series - Manual (Page 57)

RIGOL
DG1000Z Quick Guide 13
2. Current Function
Display the function name selected currently. For example, “Sine” is displayed
when the sine is selected and “Edit” is displayed when the arbitrary waveform
editing function is selected.
3. Menu
Display the operation menu of the function selected currently.
4. Status Bar
: Displayed when the instrument is connected to the LAN correctly.
: Displayed when the instrument is in remote mode.
: Displayed when an USB storage device is detected.
5. Waveform
Displayed the waveform currently selected by each channel.
6. Channel Status Bar
Used to indicating the selected status and on/off status of the channels. When
CH1 is selected, the border of the bar is displayed in yellow. When CH2 is
selected, the border of the bar is displayed in blue. When the output of CH1 is
enabled, the “CH1” in the bar is highlighted in yellow. When the output of CH2 is
enabled, the “CH2” in the bar is highlighted in blue.
Note: you can enable the outputs of the two channels but you cannot select the
two channels at the same time.
7. Frequency
Display the waveform frequency of the channel. Press Freq/Period to highlight
“Freq” and use the numeric keyboard or knob to modify this parameter.
8. Amplitude
Display the waveform amplitude of the channel. Press Ampl/HiLevel to
highlight “Ampl” and use the numeric keyboard or knob to modify this
parameter.
9. Offset
Display the waveform DC offset of the channel. Press Offset/LoLevel to
highlight “Offset” and use the numeric keyboard or knob to modify this
parameter.
10. Phase
Display the waveform start phase of the channel. Press Start Phase and use
the numeric keyboard or knob to modify this parameter.