Rose Electronics UltraVista SX - Manual (Page 9)

INSTALLATION and OPERATIONS MANUAL 5
To set the UltraVista SX up to “Learn” the monitor specifications (DDC),
press and hold both the SCROLL and ENTER buttons on the front panel
until the set-up menu displays on the front panel LCD screen. Press the
SCROLL button to cycle through the options. When the needed Learn
mode is displayed (Learn PC, Learn Mac, Learn Screen, or Exit), press
Enter to execute the learn function. The unit will obtain the DDC information
from the selected source and return to normal operation.
Operation
The operation of the UltraVista SX is a very easy and simple operation. You
will have your 2x2 video wall presentation up and running quickly since
there are no unit configuration to perform, no special software to install and
learn, and no video card adjustments to make.
The most efficient way to operate your UltraVista SX is to connect it up
using a 1x2 video splitter as shown in Figure 1. This provides you a local full
screen display of your presentation. When you need to perform
maintenance or change the presentation you can disconnect the connection
from the video splitter to the UltraVista SX and make changes without your
work being displayed on the video wall.
The versatility of the UltraVista SX makes it easy to incorporate into almost
any application. It can be interfaced to a DVI video selector and the
selector’s output connected to the unit. This configuration allows easy
selection of multiple video sources. Using an 8 to 1 DVI video selector
provides you with 8 video sources that can easily be switched to the
UltraVista SX and to your 2x2 video wall.