Rose Electronics CrystalLink USB 2.0 Fiber - Manual (Page 9)

TROUBLESHOOTING
Installation and Operations Manual 5
Figure 1 outlines the basic installation of the CrystalLink USB 2.0 Fiber
extender. The installation steps below are a guide to properly install the
units and cabling.
Figure 1. Installation
Before you install the CrystalView USB 2.0 Fiber extender, it is
recommended that you pre-plan you system layout, consisting of the
placement of the computer, the routing of the fiber cabling, and the
location of the USB device(s).
1. Connect the transmitters USB Type A cable connector to an unused
USB port on the computer.
2. Connect the provided power adapter to the power jack on the receiver
unit. Use only the furnished power adapter. Other power adapters may
cause permanent damage to the receiver unit and void the warranty.
3. Connect the fiber optical cable to the transmitter’s and receiver’s
Duplex LC connectors.
4. Connect the provided power adapter to a 100/240 V AC 50 – 60 Hz
power source.
5. Install any required software to operate the USB device(s).
6. Connect the USB peripheral to the USB Type A connector on the
receiver unit.
Verifying the installation
1. Check that the USB device is detected and installed properly in the
operating system.
2. Verify that the CrystalView USB 2.0 extender has installed correctly by
opening the Device manager and expand the USB controller section
(click on the + sign). You should see the unit listed as a Generic USB
Hub.
3. Verify the Power, Host, and Link LEDs are on and the Activity LED is
blinking. If any LED is off, check the cabling.
Transmitter Receiver
Fiber Cable
USB 1.1 or 2.0
peripherals