Roth AV DBT-001 : FM/DAB+ Radio with Bluetooth Receiver - Manual (Page 5)

rothaudio.co.uk
|
5
User Manual
English
Listening To Your Radio
hints for better reception
This radio carries a single DAB/FM telescopic antenna, to obtain the best performance, you should fully extend the antenna and adjust its
position as well as the direction until you find the best reception. For ideal DAB reception, always maintain the antenna in an upright vertical
position is highly recommended.
DAB mode
If the radio is powered up and switched on for the first time, it will automatically enter into the DAB mode and perform auto scan function.
During the scan the display will show “Scanning...” together with a slide bar that indicates the progress of the scan and the amount of
stations that have been found so far. (Figure 1)
Once the scan has finished, the radio will select the first alphanumerically found station. To explore the found stations, rotate the OK control,
and when you find a station that you would like to listen to, press on the OK control. (Figure 2)
Note: If there is no stations found after auto scan, the radio will then enter into the Tune Select Menu, you can now rotate the OK control
followed by pressing on the same control to select “Manual tune” or “Autoscan” for stations.
DAB auto scan
The auto scan will search for the entire DAB Band III channels. After the scan has finished, the first alphanumerically found station will be
automatically selected.
To activate auto scan, first press the MENU button to enter into the Tune Select Menu, then rotate the Ok control to select “Autoscan”,
finally press on the OK control to confirm, the display will show “Scanning...” and a progressing slide bar. (Figure 3)
All the stations that have been found will be stored automatically, to explore and select listening to the found stations, rotate the OK control
followed by pressing on the same control.
Figure 1 Figure 2
Figure 3
DBT-001 Manual VJ.indd 5 7/8/12 13:23:14