Rugged Cams H.4 User Manual
Page 71
Active
: Connected to storage or backup device; currently saving the data
Online
: Only connected to storage or backup device
Offline
: Not connected to storage or backup device
There are three hardware status types:
Healthy
: Connected to storage or backup device; functions normally
Warning
: Connected to storage or backup device, but error was detected; in this case,
data storing or backup cannot be made (for more information, see the
description below).
Fault
:
Not connected to storage or backup device; cannot perform data saving or
backup
1. Fault state: The storage device is completely damaged, and none of the S/W
operations can be performed. The fault state is not related to a DVR problem.
The DVR has detected the fault and stopped the recording.
2. Warning state: The storage device has a physical error that can be
corrected by the storage device or by the DVR. If the error is not taken care
of, however, the storage device is likely to be damaged (and shift to fault
state). Backing up data in the corresponding storage device and replacing the
device with a normal one are strongly recommended.
3. If there is an active storage device with a warning or a fault, a message is
displayed on the upper left part of the screen. If the user checks the {Log},
the DVR will assume that the problem has been taken care of and will stop
displaying the message.