TA Triumph-Adler CX 8048 - Manual (Page 12)

1. 4. 2 Printer part
Subject Specification
Printing method
LED Array Electro photography
Photoreceptor Organic Photoconductive Drum
Print speed 80 mm per second
(Metric) 3.3 ppm/A0 5.6 ppm/A1 Landscape
(Inch) 3.4 ppm/E 5.8 ppm/D Landscape
Print head LED Array
Resolution of print head 600 dpi x 600 dpi
Print width Maximum 914 mm (36”)
Minimum 297 mm or 11” (roll media)
210 mm (cut sheet)
Print length Maximum
(Standard)
6,000 mm for A0 / 36” wide (plain paper)
or “5 x Standard length” (plain paper)
“2 x Standard length” (tracing paper)
“1 x Standard length” (film)
(Option) 24,000 mm
Minimum 210 mm or 8.5”
Warm up time Shorter than 4 minutes 30 seconds
(At 23
o C, 60%RH, the rated voltage, and plain paper is used)
First print time 18 seconds (D Landscape)
(At 23
o C, 60%RH, the rated voltage, and plain paper is used)
Fusing method Heat and Pressure Rollers
Development method Dry type non-magnetic mono-component toner
Media (Recommended Media)
Europe/Asia model:
Plain Paper 64 g/m 2 to 80 g/m 2 , Oce Red Label (75 g/m 2 )
Tracing Paper Oce Transparent Paper (80 g/m
2
)
Film Oce 3.5MIL
US model:
Bond Paper 64 g/m 2 to 80 g/m 2 , US Bond (PB-20)
Vellum US Vellum (XV-20)
Film 4MIL (PF-4DDME)
Storage of consumables (Toner cartridge)
Store the cartridge within the temperature range from 0 to
35 degrees Centigrade and within the humidity range from 35
to 85% RH.
NOTE
If the print is longer than 6,000 mm, its image quality or the
reliability of paper feeding is not guaranteed.
NOTE
The above specifications are subject to change without notice.
Chapter 1 Before Use 1-6