Exmark Vantage 000 & Higher - Manual (Page 42)

Maintenance
Figure 37
1. Switch
2. Cam
3. Right motion control lever in the neutral operate position
4. 1/8 inch (3mm)
10. If needed, loosen the screws holding the switch
and adjust the switch.
11. Tighten the switch screws.
Caster Pivot Bearings
Pre-Load Adjustment
Remove dust cap from caster and tighten nyloc nut
until washers are flat and back off 1/4 of a turn
to properly set the pre-load on the bearings. If
disassembled, make sure the spring disc washers are
reinstalled as shown in Figure 38.
Figure 38
1. Spring disc washers
42