EverFocus SPEEDDOME EPTZ3000 User Manual
Page 14
2-13
Video Cable
A BNC cable is used for connecting an EPTZ3000/EPTZ3000I to a DVR or a monitor. An
amplifier may be needed if the video cable is too long.
Control Cable
Basically, EPTZ3000/EPTZ3000I uses a differential pair to connect to other devices by
cascading. A cable that has low signal decline can be used as a control cable.
Alarm Cable
An alarm cable is not included in the packing list. A suitable wire that has low signal
decline can be used as an alarm cable.
2.3. Initial Setup
Initial setup includes dome address, communication protocol, transmission speed, video
format, and terminal resistance settings. All of the settings should be confirmed before the
dome is installed. The control-related setting that is address, communication protocol and
transmission speed have to be set consistently with the control device such as a keyboard
or a DVR.
Notice: Please make sure the power is off before setting, and restart the
EPTZ3000/EPTZ3000I to enable a new value after changing.