EverFocus SPEEDDOME EPTZ3000 - Manual (Page 34)

3-33
OFF: Disable the private zone masking.
Press “Enter” to enter private zone setup mode, and the masking will turn into red. You
can set the masking size and position in the private zone setup mode.
In this mode, you can press
“Shift” + “6” to increase masking horizontal size;
“Shift” + “4” to decrease masking horizontal size;
“Shift” + “2” to increase masking vertical size;
“Shift” + “8” to decrease masking vertical size;
Shift Joystick to select the position where the masking is located.
“Enter” to confirm the size and position, and then the masking will turn into green again.
If you use Pelco protocol keyboard, command of private zone setting will be different.
Press “IRIS +” to enter private zone setup mode, and the masking will turn into red. You
can set the masking size and position in the private zone setup mode.
In this mode, you can press
“Focus F.” to decrease masking size;
“Focus N.” to increase masking size;
“IRIS -.” to switch the mask horizontal or vertical direction;
Shift Joystick to select the position where the masking is located.
“IRIS +” to confirm the size and position, and then the masking will turn into green
again.