KEPCO MAT Full Rack MAT 6V, 15V, 25V AND 36V MODELS - Manual (Page 11)

MAT FULL RACK 022602
1-3
1.3 SPECIFICATIONS, ELECTRICAL
a) MAT Power Module Features And Specification
TABLE 1-1. MAT POWER MODULE FEATURES AND SPECIFICATIONS
PARAMETER CONDITION
MAT POWER MODULE
1/3 RACK 2/3 RACK FULL RACK
Input Voltage Range
USER
SELECTABLE
105-125 VAC
210-250 VAC
Input Current Max
115 VAC 7.0A 14.0A 21.0A
230 VAC 3.5A 7.0A 10.5A
Input Frequency RANGE 47-63 Hz
Voltage/Current Adjust-
ment Range
RANGES
0 to 100% of rating, by preprogrammed setting,
within inherent resolution limits
Programming
Resolution
Voltage 0.024% Eo max (12 bits)
Current 0.024% Io max (12 bits)
Programming Accuracy
Voltage 0.024% Eo max
Current 0.1% Io max
Data Read Back
Accuracy via Digital Bus
Voltage 0.1% Eo max
Current 0.12% Io max
Source Effect
Voltage 0.001% Eo max
Current 0.005% Io max
Load Effect
Voltage 0.002% Eo max
Current 0.024% Io max or 4 mA (whichever is greater)
Time 8 Hour Drift
Voltage 0.01% Eo max
Current 0.02% Io max
Temperature
Coefficient/°C
Voltage 0.01% Eo max
Current 0.02% Io max
Ripple & Noise
Voltage
rms: 0.001% Eo max or 0.3 mV (whichever is greater)
p-p: 0.01% Eo max or 3 mV (whichever is greater)
Current
rms: 0.03% Io max
p-p: 0.3% Io max
Transient Recovery Voltage
150 µ sec to recover within 0.1% Eo max for 10% to 100%
step in rated load current
Temperature
Operating 0 to 50 °C
Storage -20 to +70 °C
Cooling Built-in fan, air exhaust to rear
Remote Sensing Range 0.5 volts per lead (Provision for 4-terminal connection to load)
DC Output Isolation Voltage 500 Vdc
Leakage Current Output to chassis 5 µ A rms or 50 µ A p-p @ 115V a-c
Series/Parallel Operation Consult Kepco application engineering
Output Display
3-1/2 digit LCD
Panel Meter
Switch selectable voltage/current
IndIcators 4 LEDs
Voltage and Current Mode,Output Enabled, Polarity
Reversed
Output Enable/Disable
Built in power and sensing relays controlled through IEEE
1118 bus
Polarity Reversal
Built in power and sensing relays controlled through IEEE
1118 bus