EDGE Tech Digital Picture Frame - Manual (Page 8)

7
2. Remove the plastic battery insulator (if any) on the bottom of the remote control and
make sure the remote control has a battery installed. See “Installing and replacing
battery” section if you need a new battery.
3. Use the remote control to highlight and select the Photo folder (Use the direction keys
Right, Left on the remote control to navigate and press Enter to select).
4. Highlight a picture and press Enter to view the picture.
5. Adjust the contrast of the screen using the Contrast Dial on the right side of the frame.
6. Press the Brightness key (13) to adjust the brightness setting.
7. Press the Setup button on the remote control to enter the Setup Menu .
8. Move to Slideshow Setup by pressing the Down button. Press Enter to continue.
9. Use the Down key to select the Interval Time . Use the Right direction key to enter the
time sections. Move up and down to select the desired transition time of a picture and
press Enter to select. Press the Setup button to exit the Setup menu.
Note: The Interval Time functions only when the Slide Show Mode is set to Auto.
10. To disable the slideshow function, select Setup, Slideshow Setup, Slideshow Mode
and Manual. You will be able to change the displayed picture by pressing Next (15) or
Previous (16) key.
See “Advance Settings” section for more control settings.
Caution
If you connect the Digital Picture Frame to a European-standard TV, please switch
the Digital Picture Frame to PAL mode by pressing MENU (7) and then NTSC/PAL
key (19) on the remote control.
Note:
1. The original display mode setting of the Digital Picture Frame is NTSC.
2. When viewing a picture on the Digital Picture Frame with PAL mode, the
display of the Digital Picture Frame will be come vague.
**The NTSC mode applies to North America. The PAL mode applies to all countries in
Europe . **