EverFocus EDSR-400 - Manual (Page 13)

Operation
8
(1) Insert a HDD (IDE) for Video Storage
(2) Connect cable for video/audio input and video/audio out,
The detail connection is described in SYSTEM CONNECTION.
(3) Switch Power On
(4) Press MENU key to enter SET UP MENU.
Once inside the main menu you will find there are 14 set up pages as below:
Selected item will be surrounded by a white block.
MENU
(5) Turn the JOG dial clockwise or counter-clockwise to select the item,
press ENTER key for detail set up for each item.
5. Operation
Insert one or two HDD (3.5” IDE) for Video Storage.
The HDD should be set as Master. (Set Cable Select is also available)
(Normally the default setting of HDD is Master)
Note: After hard disk case is inserted into the hard disk tray, be sure to turn the tray key
in lock position.Otherwise, HDD will not be detected.
ATTENTION: Changing HDD s and switching on HDD s is not allowed during recording!
MAIN MENU
TIMER
SEQUENCE
TITLE
COVERT
ALARM
MOTION
RECORD
NETWORK
CONTROL
BUZZER
ARCHIVE
CALL
DISK
SYSTEM
CLOCK
(6) Press MENU again to leave the set up menu.
The LCD panel in the front panel will light when you switch on the power.