SAF-HOLLAND XL-FW10054UM FWS1 and FWS2 Series Fifth Wheels - Manual (Page 14)

14 XL-FW10054UM-en-US Rev B · 2012-03-09 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
Maintenance Procedures
#

"T/FFEFE
-VCSJDBUJPO

t
.BJOUBJO
MVCSJDBUJPO
PO
GJGUI

wheel-to-trailer contact surfaces.
Use a water-resistant lithium-based
grease. Clean grease grooves if a
large amount of debris is present.
t
$MFBO
BOE
MVCSJDBUF
MPDLJOH
NFDIBOJTN

if operational difficulties arise during
the service life of your fifth wheel
(i.e. problems with coupling, uncoupling,
or pulling the release handle).
12. Slide Base Lubrication
NOTE: Slide base should be moved fore
and aft at least once a year to
maintain optimum performance.
IMPORTANT: If equipped with air
release, lubricate air
cylinder every three (3)
months or 30,000 miles.
1. With the piston shaft in the exposed
position, clean with penetrating oil
and a clean shop towel (Figure 22).
(ILS sliders-spray spring covered piston
shaft thoroughly with penetrating oil
(Figure 22).
IMPORTANT: DO NOT use any abrasives
on the exposed shaft as
they could damage the
piston shaft
2. Remove supply air line and add 2-4
drops of air tool oil to cylinder through
the supply fitting. Reinstall supply air
line (Figures 23 & 24 Traditional
Sliders and Figure 25-ILS Sliders).
3. Activate and de-activate air cylinder
2-3 times to work air tool oil into
cylinder and onto piston and verify
proper operation.
Figure 22
53"%*5*0/"-
4-*%&34
Figure 23
*-4
4-*%&3
Figure 25
Figure 24
*-4
4-*%&3
4611-:

'*55*/(
1*450/





















4)"'5
1*450/

























4)"'5
4611-:

'*55*/(
53"%*5*0/"-
4-*%&3
4611-:
'*55*/(
53"%*5*0/"-
4-*%&3