SAF-HOLLAND XL-FW421-02 XA-201-A-80-L Air Release - Manual (Page 4)

5. Slowly drive the tractor forward or backward to
position the fifth wheel.
6. Re-engage the slide locking plungers. Verify
that both plungers have fully engaged (locked),
as shown in Figure 4B.
NOTE: Retract landing gear if lowered.
1. Position tractor and trailer in a straight line on
level ground.
2. Lock the trailer brakes.
3. Release slide locking plungers.
4. Visually check that both plungers are fully
extended (unlocked), as shown in Figure 4A.
NOTE: If the plungers do not release, using low
gear on the landing gear, raise the trailer to relieve
pressure on the plungers. This will allow the fifth
wheel to slide easier.
AIR
OPERATED
MANUAL
SLIDE
Move cab switch
to unlock position.
Pull release
lever, lift up
and hook
in place.
Trip the
release lever
by tapping it
downward as
shown, and
allowing it to
spring back.
MANUAL
SLIDE
Figure 4A
Figure 4B
AIR
OPERATED
Move cab switch
to lock position.
4
Do not operate the vehicle if the
plungers are not fully engaged
(locked) and landing gear fully retracted, as
damage to the tractor, trailer and landing gear
may occur.
The trailer must be stopped and
the trailer brakes locked to
prevent damage to the tractor or trailer by
uncontrolled sliding of the fifth wheel.
OPERATING INSTRUCTIONS
Fifth Wheel Slide Adjustment
XL-FW421-02