E&J EJ777-2 - Manual (Page 18)

18 EJ777-2-INS-LAB-RevA10 • EJ777-2 Transport Chair
Store Transport Chair in car's back seat
1. Move the car's front seat as far forward as possible.
2. Holding the folded Transport Chair by the carrying straps, lift it into the car and
place it on the back seat floorboard. Stow the footrests alongside. DO NOT put any
articles on top of the Transport Chair.
Ensure the Transport Chair is stable, will not shift while the car is in motion, and
does not block the driver's field of vision.
Store Transport Chair in car's trunk
1. Holding the folded Transport Chair by the carrying straps, lift it and carefully
place it in the trunk. Stow the footrests alongside.
2. DO NOT put any articles on top of the Transport Chair. Close the trunk lid slowly.
Unfold the Transport Chair (see picture on previous page)
1. Push down on the seat rails to open.
WARNING: DO NOT place your hand or fingers between seat rails and side panels.
2. Push down again on the seat rails to lock seat rails into place in cradles.
3. Unfold the back: Raise the upper back until it locks into place; ensure that upper
back is locked into place before proceeding.
4. Install footrests.
WARNING: Ensure that Transport Chair is unfolded as instructed and that upper back
is locked into place, seat rails are locked into place on cradles, and footrests are
locked in place before occupying or operating Transport Chair.