Epson 3100Z - Manual (Page 22)

1-6 Getting Started
L Proof Sign-off:
K. Pipa CRE Tsutagawa
K. Pipa
CRE R. Hopley R4C7850
Rev. C
A5 size START.FM
4/27/01 Pass 3
2. Insert four batteries into the compartment,
positioning the and ends as shown below.
Then lower the battery cover.
w
Warning:
Do not use different types of batteries together;
this can cause fire or explosion.
3. Swing the battery cover shut and hold it down
while you slide it back to lock it, as shown below.
When the battery power is almost out, a low battery
icon
appears on the display panel. When the
battery power runs out, this icon blinks and the
camera turns off automatically. Remove the old
batteries, then insert new ones.
Note:
When the battery level is low, the LCD monitor turns off
while the flash is being charged. When the charging is
complete, the LCD monitor turns back on.
Replacing the batteries
Replace your PhotoPC 3100Z batteries when the low
battery icon
appears on the camera’s display
panel. Be sure to replace all four batteries at the same
time. You can replace them with either of the
following battery types.
Single-use AA (IEC LR6) alkaline batteries
Rechargeable AA Ni-MH batteries