DE DIETRICH DOP1180 - Manual (Page 14)

14
4 / CARING FOR AND CLEANING YOUR APPLIANCE EN
CATALYTIC ENAMEL OVEN (SELF-DEGREASING) • •
- The oven has an enclosure fitted with removable panels covered with a special microporous
enamel (catalytic enamel) which gives them self-degreasing properties. As soon as dirt appears,
it spreads out and is dispersed into the micropore holes. It oxidises on to both surfaces and gra-
dually disappears. The self-degreasing enamel is mainly suitable for fatty, rather than sugary
substances. This is why the oven floor, which is more likely to suffer sugary spillages, is not coa-
ted with this enamel.
We strongly recommend:
- That you do not scrub these catalytic panels with metal brushes, pointed or sharp implements.
- That you do not try to clean them with commercial scouring products.
- When grilling food, the temperature of the panels is not always sufficient to eliminate major fat
splashes.
In this case, when you have finished cooking, leave the oven switched on for 20 to 30 minutes
at the maximum temperature for the sequence chosen.
If there are traces remaining, they will dissipate during subsequent cooking.
B Be effo orre e s stta arrttiin ng g tto o d diis sa as ss se em mb blle e tth he e a ap pp plliia an nc ce e,,
a allllo ow w iitt tto o c co oo oll d do ow wn n a an nd d e en ns su urre e tth ha att iitt h ha as s
b be ee en n d diis sc co on nn ne ec ctte ed d ffrro om m tth he e p po ow we err s su up pp plly y..
REMOVING THE WIRE SHELF SUPPORTS (DEPENDING ON MODEL) • •
Warning
- For any cleaning operation inside the
oven cavity, the oven must be switched off.
Before you remove the back panel, the
appliance must be disconnected from the
power. After cleaning, the back panel must
be put back in place, as detailed in the
instructions.
W Wiirre e s sh he ellff s su up pp po orrtts s w wiitth h h ho oo ok ks s iin n tth he e
c ce en nttrre e..
To remove them, lift up the front part of the
shelf support to disengage the front hook
from its housing (fig.1).
Then gently pull the whole of the support
towards you and lift the back to release the
rear hook from its housing (fig.2).
Pull out the two shelf side supports.
fig.1
fig.2