Epson R-D1s - Manual (Page 13)

Getting Started 13
1
1
1
1
1
1
1
1
1
1
Installing the Battery in the Camera
1. Make sure the camera’s power switch is in the Off position, then
open the battery cover.
2. Insert the battery into the camera as far as it will go, making sure
the orientation of the battery is correct.
3. Close the battery cover until it clicks.
Note:
You can check the amount of battery power remaining in the camera by
checking the status gauge. (See page 10.)
Using a Memory Card
You cannot take pictures unless a memory card is installed in the
camera. The camera accepts SD memory cards of up to 2 GB capacity.
c Caution:
❏ Make sure there is no dirt or dust on the memory card terminal. If
it is dirty, you may not be able to read from or write to the card.
❏ Never insert or remove a memory card while the memory card
access light is on. This may cause data in the card to be lost or
damaged, or render the memory card unusable.
❏ Keep the memory card slot cover closed except when you insert or
remove the memory card. This protects the memory card and the
slot from dust particles and static shock; otherwise data on the
memory card may be lost or damaged.
❏ Static shock to the memory card may cause the camera to
malfunction.
Note:
❏ Be sure to read the documentation included with the card to make sure
you use it correctly.
❏ If the memory card has been already formatted with a computer or another
digital camera, you may not be able to save images on the card. If this
happens, reformat the card using this camera. For instructions, see
“Formatting the Memory Card” on page 40.
DUMMY
DUMMY