EchoStar 44 - Manual (Page 15)

16
4. If you do not see the information as described in step 3 of
this procedure, you will need to check all cables and
switches, and then run Check Switch again. Select
Details for information that may be helpful in trouble-
shooting the problem or in reporting it to the DISH
Network Customer Service Center.
Adding More Switches
You can install two additional DISH Pro or DISH Pro Plus
switches to the system, to support up to 12 satellite receivers
total. Add the switches by repeating the previous installation
instructions except connect the ports marked T
O
D
ISH
on
each added switch to the ports marked T
O
A
DDITIONAL
S
WITCHES
on an installed switch. See Figure 6.
Note: You must use the same group of trunk ports on each
switch throughout the system. However, cables can be
connected to any port in the group. For example: If T
O
D
ISH
port numbers c through e are connected on the first
switch, you must connect all switches together using ports c
through e .