Avago Technologies AcceleRAID 170LP - Manual (Page 31)

Installation
Manual No. DB11-000024-00 2-11
Installing the Controller Into a 2U Chassis
Follow these installation steps: (You may need to check the manufacturer’s
installation instructions for your particular 2U chassis.)
☛
Note
If the controller has the standard PCI bracket
installed, replace it with the Low Profile PCI bracket.
1. Choose the riser adapter with an available PCI slot. In this case, it is
presented on an angle (Figure 2-8).
2. With the power off, plug (install) the controller board firmly into the
32-bit PCI slot, and snap it into place (Figure 2-8).
Figure 2-8. Plug the Controller into a 32-bit PCI Slot into the 2U Chassis
In the finished installation, the controller will be in a flat, horizontal
position (Figure 2-9).
Figure 2-9. AcceleRAID 170LP Installed into a 2U Chassis
Low Profile
Bracket
AR170LP
32-Bit PCI