OPHIT DMS-H1616 - Manual (Page 4)

General Specification
4
Safety Instructions
Warning
External equipment intended for connection to signal input, signal output or
other connectors, shall comply with relevant IEC standard(e.g.,IEC60950 for IT
equipment and IEC60601 series for medical electrical equipment).
In addition, all such combination-system-shall comply with the standard IEC
60601-1-1, safety requirements for medical electrical systems. Any person who
connectors has formed at system and is therefore responsible for the system
to comply with the requirements of IEC 60601-1-1.
if, in doubt, contact qualified technician or your local representative.
- Do not dismantle the housing or modify the product.
Dismantling the housing or modifying the product may result in electrical shock
or burn.
- Refer all servicing to qualified service personnel.
Do not attempt to service this product yourself as opening or removing
housing may expose you to dangerous voltage or other hazards.
- Keep the product away from liquids.
Spilling into the housing may result in fire, electrical shock, or equipment
damage. If an object or liquid falls/spills into the housing, unplug the product
immediately. Have the product checked by a qualified service engineer before
using it again.
- Do not touch the Product with wet hands.
Touching the housing and plug with wet hands is dangerous and can cause
electrical shock.
- Do not to touch signal input, signal output or other connectors,
and the patient simultaneously.
WARNING : To avoid the risk of electric shock, this equipment must only be
connected to a supply mains with protective earth.
WARNING : Appliance inlet shall be used for mains disconnection.