Eiki EZ 250 - Manual (Page 14)

- 10 -
Reset Button
10. After the programming status disappears disconnect the cables from the
computer and press the reset button on the back of the EZ 250 and you
are ready for the installation of the EZ 250
Standard Programming for 2 Devices
1. Same as steps 1 thru 7 in Standard Programming
2. Select Projector (from the top of the EZ 250 software)
3. Enable Second Projector
4. Select Projector
5. Select Model
6. Select Control Port 2
7. Select Manufacturer
8. Select Model