PLANET IGS-10020HPT - Manual (Page 145)

User’s Manual of IGS-10020PT / IGS-10020HPT
145
4.6.10.2 VLAN Trunking between two 802.1Q aware Switch
In most cases, it is used for “Uplink” to other switches. VLANs are separated at different switches, but they need to access with
other switches within the same VLAN group. The screen in Figure 4-6-11 appears.
Setup steps
1. Create VLAN Group
Set VLAN Group 1 = Default-VLAN with VID (VLAN ID) =1
Add two VLANs – VLAN 2 and VLAN 3
VLAN Group 2 with VID=2
VLAN Group 3 with VID=3
2. Assign VLAN Member :
VLAN 2 : Port-1,Port-2 and Port-3
VLAN 3 : Port-4, Port-5 and Port-6
VLAN 1 : All other ports – Port-7~Port-24
As to the VLAN ports connecting to the hosts, please refer to 4.6.10.1 examples. The following steps will focus on the VLAN
Trunk port configuration.