EdgeStar AP14009COM - Manual (Page 17)

EdgeStar Portable Air Conditioner 14
The timer can be used to either turn the unit on or off after a number of
elapsed hours. The timer is adjustable between 1-24 hours in one hour
increments.
How to set the unit to automatically turn on
:
1) Press the Timer button while the unit and remote are powered
off. The On Timer [ ] indicator will be selected and the timed hour
indicator will be blinking.
2) Use the
Up and Down buttons to set the number of hours
you want to pass before the unit turns on.
3) Press the
Timer button again to set the timer. The timed hour
indicator will stop blinking. After the selected time passes, the unit will
automatically turn on.
How to set the unit to automatically turn off
:
1) Press the Timer button while the unit and remote are powered
on. The Off Timer [ ] indicator will be selected and the timed hour
indicator will be blinking.
2) Use the
Up and Down buttons to set the number of hours.
3) Press the Timer button again to set the timer. The timed hour
indicator will stop blinking. The unit will automatically turn off after the
selected time elapses.
Front Panel Lights and Controls
Your portable air conditioner has a front panel that lights up different
colors depending on the mode it is running.
Cooling mode will display a blue light.
Dehumidify mode will display a yellow light.
Fan mode will display a green light.
Heating mode (on some models) will display a red light.
Automatic mode will display the color of the current mode.
If the unit flashes a red light and the unit stops cooling, this indicates that
the internal water reservoir is full. Place a pan under the unit, and remove
the drain plug to drain the unit.
If the lights flash from left to right and the unit does not work, contact
customer service.
The front panel has an emergency power switch. The power switch
can be used when the unit needs to be shut off or turned on without
the remote control.
You can turn off the front panel lights by hitting the Lamp Off switch.
Timer
Front Panel Lights
Front Panel Controls
NOTE: To cancel the timer,
press
Power button or
set it at “00”.