PLANET UMG-1000 - Manual (Page 12)

12
5. Quick Setup Wizard
From this chapter, we will describe how to use PLANET View to configure and
control the UMG-1000 / UMG-1000W features and setup IT services configuration.
PLANET View enables you easily navigate through all IT configurations and
services.
5.1 First Time Login
Now that the network connection between your PC and UMG-1000 / UMG-1000W
has been established, you must login in order to access PLANET View.
Launch a web browser (for example: IE, Firefox etc.) and type the
UMG-1000 / UMG-1000W IP address in the address bar. The default address is
“http://192.168.1.1”.
If you can not see the following login page, recheck your physical LAN connection
and repeat Section “LAN Connection”. To avoid web-based management abused
by unauthorized users, the login sessions will logout automatically if the session is
inactive for more than 5 minutes. Type in an authorized username and password
and then click the button “Apply”. The default username is “admin”, and its
password is “admin” all in lower case.
5.2 Welcome to Quick Start
After the first login, an easy and short quick start up should be completed to
make the UMG-1000 / UMG-1000W service normally. There is an alternative
selection in the page “Welcome”. One selection is for “Quick Start” and the
other is for “Faster Recovery UMG to UMG” which will be explained in the user’s
manual. The quick start includes five steps which will lead administrator to setup
the UMG-1000 / UMG-1000W. Check the first radio box and then click the button
“Start” to continue.