ProSoft Technology MVI69-ADMNET - Manual (Page 39)

MVI-ADMNET ♦ 'C' Programmable Setting Up Your Development Environment
'C' Programmable Application Development Module with Ethernet Developer's Guide
ProSoft Technology, Inc. Page 39 of 122
February 20, 2013
3.4 Downloading a ROM Disk Image
3.4.1 MVIUPDAT
MVIUPDAT.EXE is a DOS-compatible utility for downloading a ROM disk image
from a host PC to the MVI-ADMNET module. MVIUPDAT.EXE uses a serial port
on the PC to communicate with the module. Follow the steps below to download
a ROM disk image:
1 Connect a null-modem serial cable between the serial port on the PC and
PRT1 on the MVI module.
2 If you are using HyperTerm or a similar terminal program for the MVI-
ADMNET module console, exit or disconnect from the serial port before
running the MVI Flash Update tool.
3 Turn off power to the MVI module. Install the Setup Jumper as described in
the Installation Instructions.
For DOS:
1 Click the S TART button, and then choose R UN .
2 In the O PEN : field, enter MVIUPDAT. Specify the PC port on the command line
as shown in the following illustration. The default is COM1.
3 Turn on power to the MVI module. You should see the following menu shown
on the host PC.
+----------------------------+
| Main Menu |
|----------------------------|
| Verify Module Connection |
| Update Flash Disk Image |
| Reboot Module |
+----------------------------+
4 Select V ERIFY M ODULE C ONNECTION to verify the connection to the MVI
module. If the connection is working properly, the message "Module
Responding" will be displayed.
Note: If an error occurs, check your serial port assignments and cable connections. You may also
need to cycle power more than once before the module responds.
5 Select U PDATE F LASH D ISK I MAGE to download the ROM disk image. Type the
image file name when prompted. The download progress is displayed as the
file is being transmitted to the module.
6 After the disk image has been transferred, reboot the MVI module by
selecting the R EBOOT M ODULE menu item.
7 Exit the MVIUPDAT.EXE utility by pressing [E SC ].