Kodak i2420 - Manual (Page 6)

A-61756 May 2014 3
Start/Resume button You can scan a document using the Start/Resume button on the
flatbed.
If you are scanning several exception documents using the flatbed, it
may be easier to use the Start/Resume button on the flatbed to start
scanning.
Indicator status:
• Steady green: flatbed is on, ready to scan, or scanning.
• Steady red: USB cable is not connected, has lost USB
communication with host PC after power up or there is a flatbed
failure or error.
• Flashing green: waiting/Power Saver mode.
Using the flatbed Use the flatbed to scan documents that cannot be scanned using the
automatic document feeder (ADF).
1. Open the flatbed cover.
2. Place the document face down on the glass platen.
3. Align the document in the lower right-hand corner at the corner
arrows.
NOTES:
• When scanning from the flatbed, be sure there are no documents in
the automatic document feeder of the scanner.
• From time to time the flatbed will perform an automatic image
calibration in order to maintain the best possible image quality. This
automatic calibration is determined by the flatbed monitoring itself
and is flatbed initiated. During this calibration process, the flatbed
motor will run and the lamps/LEDs will be illuminated.
• When scanning documents be sure the flatbed cover is closed.
• The white background on the flatbed cover must be clean and
smooth. If there are any imperfections, it may affect auto crop
performance.
When you press the Start/Resume button on the flatbed,
you will get the same result as pressing the Start/Resume
button on the scanner. The application that is associated
with the number displayed in the function window on the
scanner is launched. By default, the displayed numbers
are associated with Smart Touch. The displayed numbers
1-9 are mapped to Smart Touch task shortcuts 1-9.