Energizer 2103G - Manual (Page 20)

2103 Modem Module
Section 2 Installation and Operation
2-4
service is subject to state tariffs.
Changes in Attestation Procedure for Plugs and Jacks
Isco Inc. attests that the network interface plugs or jacks used
on this equipment comply with and will continue to comply with
the mechanical requirements specified in Part 58, sub-part F,
specifically the dimensions, tolerances and metallic plating
requirements. The compliance of these connectors will be
assured by purchase specifications and incoming inspection.
Documentation of such specifications and/or inspections will
be provided to the FCC within 30 days of their request for the
same.
Telephone Company Procedures
The goal of the telephone company is to provide you with the
best service it can. In order to do this, it may occasionally be
necessary for them to make changes in their equipment, oper-
ations or procedures. If these changes might affect your ser-
vice or the operation of your equipment, the telephone
company will give you notice, in writing, to allow you to make
any changes necessary to maintain uninterrupted service.
In certain circumstances, it may be necessary for the tele-
phone company to request information from you concerning
the equipment which you have connected to your telephone
line. Upon request of the telephone company, provide the FCC
registration number and the ringer equivalence number (REN);
both of these items are listed on the equipment label. The sum
of all the RENs on your telephone lines should be less than
five in order to assure proper service from the telephone com-
pany. In some cases, a sum of five may not be usable on a
given line. Consult your telephone provider.
If Problems Arise: If any of your telephone equipment is not
operating properly, you should immediately remove it from your
telephone line, as it may cause harm to the telephone network.
If the telephone company notes a problem, they may tempo-
rarily discontinue service. When practical, they will notify you in
advance of this disconnection. If advance notice is not feasible,
you will be notified as soon as possible. When you are notified,
you will be given the opportunity to correct the problem and will
be informed of your right to file a complaint with the FCC. Con-
tact your local telephone service provider if you have any ques-
tions about your phone line.
In the event repairs are needed on the 2103 Modem, they
should be performed by Teledyne Isco Inc. or its authorized
representative. For information, contact the Teledyne Isco Cus-
tomer Ser vice Depar tment at (800) 228-4373 or (402)
464-0231.