Energizer 2103G - Manual (Page 36)

2103 Modem Module
Section 4 2103G Cellular Modem Module
4-4
When you are ready to connect the in-street antenna to the
2103
G modem, you will need to assemble the connector shell onto
the end of the cable. The pieces of the connector shell are shown
in Figure 4-5. An instruction sheet (P/N 60-2003506) is shipped
with the antenna, and shows you the assembly steps.
Figure 4-5 Protective connector shell pieces for the in-street antenna
To connect an antenna to the 2103 G , twist the protective con-
nector shell (Figure 4-6) to loosen its components. Slide the com-
ponents down the cable to reveal the gold connector end.
Figure 4-6 Connecting an antenna to the 2103 G
When the gold SMA connector is tightly attached to the modem,
slide the connector shell forward. Press down on the metal latch
on the side of the modem and push the connector shell onto the
modem, as shown in Figure4-7.
Twist the connector
shell to loosen its
components.
Slide the components
down the cable, and
connect the gold
connector end to the
modem.