Ericsson TT1222 - Manual (Page 10)

2BInstalling the Equipment
2.5 Connecting the Receiver to the Power Supply
Warnings!
Do not overload wall outlets and extension cords as this can result in a risk of fire or
electric shock.
As no mains switch is fitted to this unit, ensure the local power supply is switched
OFF before connecting the supply cord.
The Receiver is not fitted with an on/off switch. Ensure that the socket-outlet is
installed near the equipment so that it is easily accessible. Failure to isolate the
equipment properly may cause a safety hazard.
Connect the Receiver to the power supply as follows:
• Power Supply
Ensure the power supply is isolated and switched off.
• Receiver
Ensure the correct fuse type and rating has been fitted to both the equipment
and the power cable.
• Supply Cord
Connect the lead to the Receiver input connector and then to the power supply.
Switch on the power supply.
Table 5 Fuse Type and Rating
Power Supply Fuse Type and Rating
100-240 V AC –10% +6% at
50/60 Hz nominal 5 x 20 mm
IEC/EN 60127-2 Sheet 2
Hollyand 5OF or Littelfuse 617
F3.15 A 250 V
Note: The Internal fuse is not user replaceable
Refer to the Reference Guide for all power supply, fuse, safety, EMC
information and operating conditions.
EN/LZT 790 0002/1 R1A 2011-02-21 10 (20)