Elo TouchSystems 1220L - Manual (Page 8)

7
Start Your Installation
u Tilt
Grasp both sides of the monitor screen with your hands and adjust the
tilt as desired.
u Connecting the Touchmonitor (Figure 7.1)
To setup this touchmonitor, please refer to the following figure and proce-
dures.
1. Be sure all equipment is off.
2. Connect the VGA signal cable from display input connector to the
15-pin connector of your host computer and tighten the screws.
3. Connect the female end of the touchscreen cable to the serial port on
the back of your PC, and the male end of the cable to your
touchmonitor.
4. Connect the DC power cord to the power connector; plug one end of
the AC power cord into the power adapter, and then the other end into
an electrical outlet.
5. Connect the Audio-In cable from audio input port of your touchmonitor to
the Audio-out port of your computer. If you need to use earphone,
connect your earphone cable to the earphone port of your display.
6. Turn on both your computer and touchmonitor.
u
Install Driver Software
Please refer to page 20 for driver software instructions.