Eclipse - Fujitsu Ten Mainboard D2140 - Manual (Page 20)

Pin assignment of internal ports
A26361-D2140-Z120-1-7419, edition 1 English - 11
Pin assignment of internal ports
The pin assignment of some internal connections is shown in English in the following.
i Some of the following connectors may be optional!
Front panel
Watch the poling of the LEDs. The positive pole
of the connection cables is often indicated with a
coloured wire.
1
2
HD-LED
1)
Reset
1)
1) Cable is not included in the delivery scope.
2) 2-pin or 3-pin connector possible
3) both connector positions possible
Recovery Password
Power On/Off
3)
Power On
1) 2)
LED
Connection Note
Reset Connector for reset switch
Power On/Off Connection for ATX On/Off switch
HD LED Indicates HDD (hard disk) activity
Power On LED Indicates the system state APM or ACPI
Password see "Settings with switches and jumpers" chapter
Recovery see "Settings with switches and jumpers" chapter
USB - dual channel
(internal or external via special wire)
1 2
Pin Signal Pin Signal
1 VCC C 2 VCC D
3 Data negative C 4 Data negative D
5 Data positive C 6 Data positive D
7 GND 8 GND
9 Key 10
not connected