Quickstart – Samson XPD2 Headset USB Digital Wireless System User Manual
Page 10
XPDm Digital Wireless
10
In order for the XPDm Digital Wireless System to work correctly, both the RXD1m
receiver and HXD1 handheld or PXD1 beltpack transmitter must be paired together.
(NOTE: The XPDm Digital Wireless System will come paired from the factory).
Follow this basic procedure for setting up and using your XPDm Digital Wireless
System:
1.
Physically place the RXD1m receiver where it will be used. We suggest you keep
receiver and transmitter within line of sight for optimal performance, meaning
the performer using or wearing the transmitter can see the receiver.
2.
Connect the included power adapter to the RXD1m receiver before turning the
power on. Turn the RXD1m on momentarily to confirm that it is receiving power,
then turn it off (figure 1).
3.
With your amplifier or mixer powered off and
volume control down connect the RXD1m
receiver output jack to the mic or line input
using the balanced XLR output, unbalanced
1/4” or 1/8” output jacks. Turn the RXD1m
power on but keep the volume at minimum
level (figure 2).
4.
Place a fresh set of AA (LR6) batteries in the
transmitter’s battery compartment being sure to observe polarity markings (figure
3).
Quickstart
Figure 2
Figure 3
Figure 1