Samson AirLine AHX Wireless UHF Fitness Headset System (D: 542 to 566 MHz) - Manual (Page 11)

AirLine ATX Wireless System 11
ENGLISH
FRANÇAIS
DEUTSCHE
ESP
AÑOL
IT
ALIANO
ATX Transmitter Callouts
1. Power/Mute Button - Press and hold for 3 seconds to turn the unit on or off.
A quick press and release will mute or unmute the transmitter when the
transmitter is on.
2. Status Indicator - This LED displays the operation mode, low battery and recharge
status of the transmitter. The chart below defines the LED colors for each
function.
GREEN Normal Operation
AMBER Mute
Flashing RED
Low Battery
Charging
RED Fully Charged
3. Volume +/– Buttons - Press and hold either Volume button to adjust the volume.
Pressing the + or – button increases or decrease the level by one step with each
push of the button. There is a total 9 volume levels. The Status Indicator light
will flash faster for each increased step and slower for each decrease.
4. IR Lens - This window is used to capture the infrared signal sent from the receiver
during the IR SET to channelize the transmitter. The IR Lens is only active for
the first 10 seconds when the transmitter is powered on.
5. Charging Connector - Connect the supplied magnetic charging cable to this
sealed, gold contact charging connector to recharge the internal Lithium Ion
battery. The ATX can be recharged by connecting the cable to a USB connector
on a computer USB port, or any 5-volt DC adapter that has a USB output.
NOTE: The included adapter will charge the ATX faster than a computer USB
port.
6. Input Connector - Connect the input device via the mini-XLR connector. The ATX
is supplied with either a lavalier, headset or instrument microphone.
7. Spring Clip - Use this clip to fasten the ATX transmitter to a belt, waist band or
instrument bell.
3
8
1
2
4
5 6
7