Samson AirLine AHX Wireless UHF Fitness Headset System (D: 542 to 566 MHz) - Manual (Page 9)

AirLine ATX Wireless System 9
ENGLISH
FRANÇAIS
DEUTSCHE
ESP
AÑOL
IT
ALIANO
Charging the ATX Transmitter
1. Snap in place the appropriate mains connector plug into the adapter.
2. Insert the magnetic power cable to the included USB AC plug (or any 5-volt DC
adapter that has a USB port). Insert the AC plug into an electrical outlet.
3. Place the ATX transmitter on a flat surface.
4. Attach the magnetic connector to the gold contact power port on the bottom of
the ATX transmitter. The cable attaches to the port magnetically.
The magnetic connector is keyed so it will only connect in one direction.
Note: Transmission is disabled during charging.
5. Look at the indicator light on the ATX transmitter to determine when the
transmitter has finished charging. When the light is flashing red, the ATX is
charging. When the red light stops flashing it indicates that the ATX is fully
charged.
6. Disconnect the magnetic power cable from the ATX when the unit is fully
charged.
If you notice your ATX battery life is becoming shorter after a full charge, you can
order a user replaceable battery from your local Samson distributer.
Getting the most out of the rechargeable battery:
• Completely charge the batteries before first use
• Fully charge the battery before it will be used.
• After the battery is charged, unplug the charger from the outlet or
remove the battery from the charger.
• The optimal temperature range for using and storing the battery is
50°F - 86°F (30°C - 50°C). The battery performance and operation
may decrease in temperatures below 50°F (30°C).
A warning that batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type. Attention should be drawn to the environmental aspects
of battery disposal