Detaching the table-top stand from the lcd display, Remove the screws from the rear of the lcd display – Sony WH-XB910N EXTRA BASS Noise-Canceling Wireless Over-Ear Headphones (Black) User Manual

Page 6

Advertising
background image

6

(US)

4

Detaching the Table-Top Stand
from the LCD Display.

To detach the Table-Top Stand from the LCD
Display, remove the screws .

Note

• Be careful when lifting the LCD Display as the Table-

Top Stand is detached, the Table-Top Stand may
topple over and cause personal injury.

• Take care when removing the Table-Top Stand from

the LCD Display to prevent it from falling over and
damaging the surface that the LCD Display is sitting
on.

• Do not remove the Table-Top Stand for any reason

other than to install corresponding accessories on
the LCD Display.

• Be sure the LCD Display is vertical before turning

on. To avoid uneven picture uniformity do not
power on the LCD Display with the panel facing
down.

• When attaching the Table-Top Stand again, be sure

to fasten the screws (previously removed) to the
original holes on the rear of the LCD Display.

FW-75BU30J / 65BU30J / 55BU30J / 50BU35J /
50BU30J / 43BU35J / 43BU30J / 75BZ30J /
65BZ30J / 55BZ30J / 50BZ35J / 50BZ30J /
43BZ35J / 43BZ30J

1

Remove the screws from the
rear of the LCD Display.

When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
Do not lift the Mounting Hook before the screws
(two screws each for left/right) are secured. This
may distort the Mounting Hook or the LCD Display
cabinet.

2

Attach the Wall-Mount
Attachment (supplied with the
LCD Display) to the rear of the
LCD Display (to make it parallel
with the wall).

Note

• Be sure to fasten the Wall-Mount Attachment when

attaching them to the LCD Display. Use only a flat
head screwdriver to install the Wall-Mount
Attachment. Use of another tool might result in
over torqueing the Wall-Mount Attachment and
damaging the LCD Display.

3

Attach the Wall-Mount Bracket
(not supplied) using the screws
(not supplied).

Note

• If using an electric screwdriver, set the torque at

approximately 1.5 N·m {15 kgf·cm}.

VS

VS

Supplied with the
LCD Display

Wall-Mount
Attachment (4)

1.5 N·m
{15 kgf·cm}

Screw (not supplied)

Wall-Mount Bracket
(not supplied)

Advertising