Usb type-c mode, Updating the monitor, Downloading the hp firmware installer – HP Z32k G3 31.5" 4K HDR Monitor User Manual
Page 31: Updating firmware for the monitor
2.
To set the external monitor as the primary monitor, select Second screen only.
or
To set the external monitor as an extension of the primary monitor, select Extend.
or
To set the external monitor as a copy of the primary monitor, select Duplicate.
USB Type-C mode
When a Thunderbolt or USB Type-C cable is connected to the computer and Alt mode is detected, the monitor
switches to the USB Type-C mode and the following features are activated.
■
Connect a Thunderbolt or USB Type-C cable to activate the following features in USB Type-C mode.
●
PXE boot
●
MAC address pass through: Your computer might support MAC Address Pass Through from the on, off,
sleep, or hibernation states, or only when the computer is on or in the sleep state.
The MAC Address Pass Through is supported for UEFI PXE boot.
●
Wake on LAN (WOL): Your computer might support WOL from the off, sleep, or hibernation states, or
only when the computer is on or in the sleep state.
WLAN-LAN switching is supported only on select computers running the Windows 10 operating
system.
Connect one end of the network cable to the RJ-45 (network) jack on the monitor and connect the
other end to an RJ-45 wall jack or router.
●
Single power on: Pressing the monitor power button can also turn on power to the computer.
Updating the monitor
This section describes how to download and update the firmware for the monitor.
Downloading the HP firmware installer
To download the HP firmware installer, follow this procedure:
1.
Go t
2.
Select Get software and drivers, and follow the on-screen instructions to find your monitor.
3.
Follow the on-screen instructions to select and download the HP firmware installer.
4.
Complete the installation wizard.
Updating firmware for the monitor
To update the monitor firmware while connected to your computer:
1.
Open Windows Explorer and navigate to where you saved the HP firmware installer.
2.
Double-click to execute the installer file.
26
Chapter 3 Using the monitor