EverFocus Speed Dome EPTZ3000I - Manual (Page 23)

2-22
Note: In order to protect the bulb from dirt and scrape, please put on the gloves before
installing the bulb.
7. Turn on the power, and start to operate the EPTZ3000.
Note: When turning on the power, EPTZ3000 will enter self-inspection mode, and carry out
a self-testing program. After finishing self-inspection, you can start to operate the
EPTZ3000.
2.4.3. EPTZ3000I Dome Camera Installation
1. Take off the housing from the packing, and take off the PCB board (4 bolts on it) inside
the housing.
2. Cut the ceiling against the housing’s shape with a saw.
The exact diameter for cutting circle is 202 mm. It cannot exceed 213 mm, because
speed dome housing may across the ceiling without any support. Please leave a
profound space of 144.5 mm, so that the housing can be perfectly inserted to the
ceiling.
3. Thread the cable through the screw and the hole on the top of the housing, and tighten
up the screw to fix the cable
4. Place the housing into the hole that you just made. Fix the housing on the ceiling with
two clips, adjust the screws of clips to make the housing perfectly fit to the ceiling.
5. Connect the cable connectors to the nodes on the base board, and then fix the base
board in the housing by screwing 4 bolts on it.