Easy PocketNAV.com 5 - Manual (Page 58)

User's manual OnCourse Navigator 5
- 56 - Indicating a destination
Note: You need not make entries into the Category field.
Their purpose is only to shorten the Point of interest list.
This list may become very extensive, especially in big cities.
5.3.3 Selecting destinations from the contacts
This function is only available in "Extended mode".
For information on how to change the user mode, please refer
to "Changing the user mode", page 38.
Using a contact's
address as
destination…
Any address from the contacts on your Pocket PC may be used as
destination for navigation or route planning purposes.
In order to identify an address clearly and without ambiguity,
city, ZIP code, street, and house number should be indicated.
Note: Only contacts the address of which is covered by the
currently loaded map may be used for navigation or route
planning purposes.
Incomplete address If an address cannot be identified without ambiguity e.g. because
there are two cities with the same name on the map, OnCourse
Navigator lists them all, indicating their ZIP codes and districts.
Select the respective city and tap OK.
If the city has been found but the street of the contact is not
indicated, you will be guided to the centre of this city.
To avoid problems, the addresses from your contacts should be
complete.
Extended mode 1. In the M AIN MENU , tap Navigation.
The D ESTINATION screen opens.
Tap the Region entry field and select the country (or state,
or province) of your destination if it is not yet indicated.