Extron Electronics RGB 192 - Manual (Page 7)

RGB 190F, RGB 192, and RGB 198 • Installation and Operation RGB 190F, RGB 192, and RGB 198 • Installation and Operation
Installation and Operation, cont’d
2-3
Installation Overview
This is an overview of the installation process. You will find
detailed installation and operation instructions in this chapter.
Install and set up the RGB 190F, RGB 192, or RGB 198 interfaces
by following these basic steps:
1 Turn off all of the equipment (computers, remote controls,
interface, projector/monitor, local monitor and speakers
or other audio device). Disconnect the power cords from
the power source.
2 Install the rubber feet for tabletop use, or install the
appropriate brackets to rack mount the interface. See
Mounting the Interfaces below.
3 Connect the input (computer video and audio [RGB 192
and 198 only
]) and outputs (display, local monitor, and
audio [RGB 192 and 198 only]). See Connections and
Switches in this chapter.
4 Set the front panel DIP switches. See Connections and
Switches, in this chapter, as a guide.
5 Connect power cords and turn on the devices: output
devices (projector, monitors, speakers [RGB 192 and 198
only
]), interface, and the source computer.
6 Adjust horizontal centering and set the Level DIP switch
to obtain the best picture.
Mounting the Interfaces
The interfaces provide several mounting options: tabletop
placement, under-desk mounting, through-desk mounting or
(for the RGB 198 only) rack mounting. Follow the appropriate
procedure on the next three pages.
Tabletop placement
For tabletop or desktop placement only, install the self-adhesive
rubber feet/pads (provided) onto the four corners of the bottom
of the interface enclosure.
Under-desk mounting
1 . Secure the included under-desk mounting brackets
(part #70-077-01) to the interface with the machine screws
that are already installed in the side of the interface
(figure 2-1).
Installation and Operation
2-2
M O N IT O R H -S H IF T S E R R D D S P N O MO N . M . A U D I O
S O G L E V E L R G B 1 9 2
C O M P U TE R
AU DIO
1 ON 2 3 4 5 6
MO NIT OR H-S HIF T SE RR
DD SP NO M ON . M. A UD IO
SO G LE VE L
RG B 1 92
CO MP UTE R
AU DIO
1 ON 2 3 4 5 6
Figure 2-1 — Under-desk mounting
2 . Hold the interface with attached brackets against the
underside of the desk or other furniture. Mark the
location of holes for screws on the desk.
3 . Drill pilot holes 1/4" (6.4 mm) deep, and 3/32" (2 mm)
diameter in the table or desk at the marked screw
locations from the underside/inside (concealed side) of
the furniture, where the interface will be located.
4 . Insert the four wood screws into the pilot holes. Fasten
each screw into the installation surface until just less than
1/4" of the screw protrudes.
5 . Align the installed screws with the slots in the mounting
brackets, and place the interface against the surface, with
the screws through the bracket slots.
6 . Slide the interface slightly forward or back, then tighten all
four screws to fasten it in place.
Through-desk mounting
1 . If rubber feet were installed on the interface, remove them.
2 . Insert the machine screws that are already installed in the
side of the interface through the slots in the through-desk
mounting brackets (part #70-077-02), and loosely secure
the brackets to the interface (figure 2-2).