EchoStar 9630 LP - Manual (Page 6)

Page 4
KIT CONTENTS:
1. Unpack and identify all components (Fig. 4).
SECTION 3
INSTALLATION
Fig. 4
TOOLS AND MATERIALS REQUIRED:
- drill and drill bit set
- tape measure
- 7/16” open end wrench (coax connections)
- adhesive sealant (compatible with roof material)
- appropriate fasteners to install all components and wiring
- 5/32” allen wrench, channel lock or pliers (to remove shipping bolts)
- wire cutter (to remove shipping tie strap)
KING CONTROLS
KING-DOME
KING DOME
OPERATING INSTRUCTIONS
1. Turn on TV
2. Go to signal meter screen and choose
transponder number for dish or direct tv.
3. Enter local zip code on signal meter
screen to determine satellite elevation..
4. Press UP arrow to turn King Dome on.
5. Press UP or DOWN arrow to display dish
elevator and match to elevation on signal
meter screen on tv.
6. Press and hold RIGHT arrow for 10 seconds. Dish will perform a 360 degree
scan for satellite. When signal strength
appears on tv, press ANY BUTTON to
stop dish from rotating.
7. Press the UP, DOWN, RIGHT or LEFT
arrows to fine tune signal strength to the
highest possible number on tv signal
meter screen.